You will see a pale nearly white area little bigger than a dime about an inch and a half down. At the center of that is the screw you need to turn to raise and lower the lights. Your owner's manual should confirm this, but I beleive it is counter clockwise to lower and the opposite to raise. Reply Like.
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall. For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Put the HBT in the front of one of the car lights, about 20-50 cm. from the car. Look trough the visor and look for a horizontal part of the car, or two symm

S8:E6- Detailed Overview How to safely remove a headlight lens from it's rear housing, using the oven technique, performed on headlights removed from the Wid

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall. The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support. This video will guide you through the proper technique for adjusting the headlamps on your Ford vehicle. Learn more about Ford support here: E90MSQb. 460 936 737 485 932 33 324 262

how to adjust ford focus headlights